Nano Prep Clay Mitt Blue

Autobright Nano Prep Clay Mitt Blue medium Grade
The best product for Paint Decontamination

Using this Clay Mitt is the quickest and easiest method to remove contaminants from your vehicle producing an amazingly smooth surface prepared for paint renovation, waxing or paint sealant application.

This new process is much quicker than using the traditional clay bar, saving you time and money and is the perfect accessory to use in the important preparation stage.

Our Nano Prep Clay Mitt consists of one side microfibre and the other constructed in a high-tech polymer coating that whilst washing your vehicle, removes above surface contaminants such as rail dust, fresh tree sap, water spots and paint overspray from paintwork, glass, mouldings, plastic and metal.

The design of the mitt allows for an effortless easy glide over the surface when used with our Autobright Clay Mist or a high polymer shampoo such as our Autobright Gloss Shampoo.
The mitt is easily cleaned of contaminants by rinsing in a bucket of water.

General shampooing and snow-foaming will not remove embedded contaminants and these may not always be visible to the naked eye, but when you glide your hand over the surface it will feel rough.
If the surface isn’t smooth then your polishes will not be as effective and your wax or sealant coating will not fully bond to the surface.

If you are an avid car enthusiast that wants pure perfection, then this is the perfect accessory for your
detailing kit.
Until recently the way to remove contaminants was to use a clay bar, but our Autobright Nano Prep Clay Mitt takes paint decontamination to an advanced level.

No need to reshape or mould the clay and if it is dropped you do not need to discard it
– just simply rinse in a bucket.

How to Use:
Wash your vehicle to remove all loose surface contamination.

Spray panel with Autobright Clay Mist or a soapy water mix of Autobright Gloss Shampoo.

Wear the clay mitt with the advanced polymer rubber layer facing the surface to be cleaned.
Using gentle pressure, glide the mitt over the wet surface; there is no need to use heavy pressure.

Once you feel the resistance drop rinse the mitt in a bucket of clean water to remove any contaminants and move on to the next panel.
Rinse with clean water and dry using an Autobright waffle weave drying towel.

Note:
Blue medium grade clay mitt is designed for vehicles with moderate to heavy contaminants

Red heavy grade clay mitt is designed for vehicles with heavy contaminants.